English
Inicio
Compañía
Productos
Instalaciones
Personal
Localización
Contacto
White semiflexible mortar-glue with a great impermeability and flexibility, suitable for tile placing in swimming pools.
Also used for walls in wet areas.
Ceramics: Medium-low absortion.
To be used iver concrete and cement walls and floors.
* Semiflexible
* Monocomponent
* Thin layer application
* Frost resistant and high humidity resistance.
1- Pour the water first and then, the mortar-glue.
2- Mix in bowls in an approximated proportion of 6-6,5 litres each 25 kgs.
3- It's very important to not add more water than recommended, physical and chemical conditions would be then, reduced.
4- Mix by hand or with a mixer machine (better slow, 500 rpm) until getting a creamy paste.
5- Let it repose during 5 minutes before applicate, for the additives to act correctly and the, mix again before use.
6- Never add water after the paste reposes.
* Substrate must be clean and dry.
* In case of concrete, make sure of its retraction and that it has no curer or sealer products (in such a case, give a PRIMER layes before).
* Extend the product with the straigh part of the trowel to ensure a full contact
* Apply the dented trowel (no. 5-7) in 1,5-2 m2 squares.
* Check that no film is formed on the surface of the adhesive (in such a case, pass the trowel with some fresh product). * Over floors in a bad state, we recommend to use PANZER FLEX.
* After 24 hours, cover the joints with a hydrofuge product, TAPAZUL or JUNCOLOR and impermeabilize them with ADESILATEX 1000.
* To clean swimming pool tiles and reinforce joints, use TAPAZUL.
Ceramic material placing for exteriors, on swimming pools.
Using substrates: Concrete, cement, cement-lime mortar and cement floors.
Substrates must be solid, hard, clean and dry, without cracks or deformations.
Do not use: Over metal, fiber-cement, wood (non flexible), tiles and old tiles.
In these cases, mix the product with ADESILATEX 1000.
Aspect
Presentation
Thickness of the paste in swimming pools
Thickness of the paste in walls and floors
Outout in walls
Mix water
Initial adherence according to UNE EN 1348
Adherence after water immersion according to UNE EN 1348
Adherence after frost cycle according to UNE 1348
Fire Reaction
Slip in vertical wall UNE EN 1308
Temperature during application
Paste density
Stockage
(from manufacturation date, under cover, in a dry place)
White powder
25 kgs bag
from 2 to 6 mm
from 3,5 to 4 kgs/m2
from 6 to 9 kgs/m2
6-6,5 litres each 25 kgs
1,0 N/mm2
0,6 N/mm2
0,7 N/mm2
A1
< 0,5 mm
min 5ºC
1,5 gr/cm3
12 months
* White cement
* Siliceous soils
* Redipensable additives and resins
Product components are not contact toxic but are toxic to ingestion (in such as a case, go asap to an emergeny health service).
Keep away from children or animals.
Skin: Wash with plenty of water
Eyes: Wash with plenty of water
Ingestion: Rinse with water and drink plenty of water
It's on customer's responsibility the admission and control in the distributor's warehouse or construction, as well as the election of the product to be used on each case. Manufacturer's responsibility is limited to manufacturation defects and for the value of the merchandise because it's out of his control the material election and the work conditions.
Technical sheet for 2007.
