English
Home
Company
Products
Factories
Staff
Locations
Contact
It's a white mortar-glue, for medium-high absortion ceramics walls, for interiors and thin layer, over surfaces with gypsum presence such as:
* Gypsum board panels
* Gypsum covered walls
* Big format brick walls
* Gypsum-covered brick walls.
* Monocomponent mortar-glue
* Nule vertical slip
* Thin layer application for interiors
* It contains retainers that prevent that forging necessary water is absorbed by the wall.
1- Pour the water first and then, the mortar-glue.
2- Mix in bowls in an approximated proportion of 7,5 litres each 25 kgs.
3- It is very important to not add more water than recommended, because physical and chemical conditions would be then, reduced.
4- Mix by hand or with a mixer machine (better slow, 500 rpm) until getting a creamy paste.
5- Let it repose 5 minutes for the additives to act correctly and then mix again before use.
6- Never add more water after the paste has reposed.
* Substrate must be clean and dry.
* Extend the product with the smooth part of the trowel to ensure a full contact with the wall.
* Apply the dented trowel (no. 6-8) in 1,5-2 m2 squares.
* Check that no surfacial film is formed over the adhesive.
In such a case, it's enough to pass the trowel again with some fresh product.
* Place the ceramic leaving 2-3 mm joints.
* We recommend to leave 3 mm expansion joints in the extremes of the walls.
Ceramic materials placing, for interiors.
Using substrates: Traditional gypsum covered walls, plaster, boards, gypsum boards, big format bricks and gypsum covered bricks.
Do not use: Over metal, fibercement, wood, tiles and old tiles.
In these cases, mix with ADESILATEX 1000.
Aspect
Presentation
Thickness of the paste in walls
Output in walls
Mix water
Open time according to UNE EN 1346
Rectification time
Initial adherence according to UNE EN 1348
Adherence after water immersion according to UNE EN 1348
Adherence after frost cycle according to UNE EN 1348
Fire Reaction
Waiting time for rejointment
Wall vertical slip according to UNE EN 1308
Temperature during application
Paste density
Stockage
(from manufacturing date, under cover, in a dry place)
White Powder
25 kgs bag
from 3 to 5 mm
from 3,5 to 4 kgs/m2
7,5 litres each 25 kgs
20 minutes
10 minutes
1,6 N/mm2
0,9 N/mm2
0,7 N/mm2
A1
4 - 6 hours
< 0,5 mm
min 5ºC, max 32ºC
1,6 gr/cm3
12 months
* White cement
* Siliceous soils
* Additives and resins
Product components are not contact toxic but are toxic to ingestion (in such as a case, go asap to an emergeny health service).
Keep away from children or animals.
Skin: Wash with plenty of water
Eyes: Wash with plenty of water
Ingestion: Rinse with water and drink plenty of water
It's on customer's responsibility the admission and control in the distributor's warehouse or construction, as well as the election of the product to be used on each case. Manufacturer's responsibility is limited to manufacturation defects and for the value of the merchandise because it's out of his control the material election and the work conditions.
Technical sheet for 2007.
