English
Home
Company
Products
Factories
Staff
Locations
Contact
PAPRESA Projection Grasp Paste is a white adhesive with plaster base to be projected with projection machine over brick walls (specially big format bricks) in order to glue the gypsum boards.
* Excellent workability.
* High performance.
* Suitable thicken for projecion machine work.
* Minimum joint retraction.
* Great resistance to flexion and compression.
1- Pour the product into the projection machine.
2- Adjust the pression and the water flow until getting a suitable thicken of the paste.
3- Never use more water than recommended, physical and chemical conditions would be then, reduced.
GYPSUM BOARD WALL PLACING
* Present the gypsum board over the big format brick walls.
* Prepair the boards, readjusting, levelling and cutting the outlets, boxes, etc.
* Retire the boards from the walls.
* Project the product with the machine, covering the wall completely.
* With a 10-15 dented trowel, comb the surface to fill all the wall irregularities.
* Stick the boards over the wall, pressing to compact it.
* Fill the joints with tape and 'Joint Paste' PAPRESA,
Aspect
Presentation
Output
Mix water with machine
Use time
Forging time
Temperature during application
Thermical resistance
Product oldage
Paste density
Compression resistance according to rule UNE 102031:1999
Fire Reaction
Adherence according to rule UNE EN 12860
Stockage
(from manufacturation date, under cover, in a dry place)
White powder
25 kgs bag
4-5 kgs/m2
1000 litres/hour
2 hours
4-5 hours
min 5ºC, max 32ºC
from -5ºC to 80ºC
not in 50 years
1,2 gr/cm3
7 N/mm2
A1
OK
12 months
* Plaster with over 95% calcium sulphate richness.
* Organic and unorganic additives.
* Plastifiers and impermeabilizers.
Product components are not contact toxic but are toxic to ingestion (in such as a case, go asap to an emergeny health service).
Keep away from children or animals.
Skin: Wash with plenty of water
Eyes: Wash with plenty of water
Ingestion: Rinse with water and drink plenty of water
It's on customer's responsibility the admission and control in the distributor's warehouse or construction, as well as the election of the product to be used on each case. Manufacturer's responsibility is limited to manufacturation defects and for the value of the merchandise because it's out of his control the material election and the work conditions.
Technical sheet for 2007.
