English
Home
Company
Products
Factories
Staff
Locations
Contact
It's a paste for joint filling and sealing from 3 to 15 mm entre cerámicas de todo tipo de absorción.
Available on: WHITE, BLACK, GREY AND TOBACCO
* Monocomponent paste (only needs water)
* Joint filling from 3 to 15 mm
* Excelent workability and easy application
* High hardness and freezing resistant
* Allows transpiration (Permeable)
* Hidrofuge
1- Pour the water first and then, the joint-coverer paste.
2- Mix in bowls in an approximated proportion of 4,5 litres by bag.
3- It's very important to not adding more water than recommended because chemical and physical conditions of the product would be reduced.
4- Mix by hand or with a mixing machine (better slow, 500 rpm) until getting a creamy paste.
5- Let it repose 5 minutes for the additives to act correctly and then mix again before use.
6- Never add water after the paste has reposed.
* 24 hours must pass after placing the ceramics to proceed to its rejoining.
* Clean well all the joints of product excess.
* Mix JUNCOLOR until getting a creamy paste and without clots.
* Refill the joints with product; this operation can be done with different tools: Brush, thin brush, filling pistol, gum spatula or rubber trowel.
* Once the joints are refilled let the product repose until it starts becoming hard, when the excesses of product will be taken off with a wet sponge.
* After 24 hours, clean the surface with a wet cloth.
Aspect
Presentation
Joint width
Output
Mix water
Use time
Transitability time
Temperature during application
Thermical resistance
Paste density
Stockage
(from manufacturing date, under cover, in a dry place)
Powder
25 kgs bag
from 3 to 15 mm
(*)
7,5 litres per each 25 kgs
1 hour
24 hours
min 5ºC, max 32ºC
from -5ºC to 80ºC
1,6 gr/cm3
12 months
(*) Output: JUNCOLOR output changes depending on joints depth and width, as well as the measures of the ceramic pieces, according to attached board (approximated consumptions).
5X5
10X10
20X20
20X30
25X25
33X33
45X45
4
5
8
10
12
10
10
2
2
6
5
10
8
15
0,6
0,4
0,9
0,8
1,7
0,9
1,1
* Cement
* Organic and unorganic additives
* Impermeabilizers and plastifiers
Product components are not contact toxic but are toxic to ingestion (in such as a case, go asap to an emergeny health service).
Keep away from children or animals.
Skin: Wash with plenty of water
Eyes: Wash with plenty of water
Ingestion: Rinse with water and drink plenty of water
It's on customer's responsibility the admission and control in the distributor's warehouse or construction, as well as the election of the product to be used on each case. Manufacturer's responsibility is limited to manufacturation defects and for the value of the merchandise because it's out of his control the material election and the work conditions.
Technical sheet for 2007.
